Ericsson IP DSLAM, EDN312 manual Cabling of Subscriber Lines

Cabling

3 Cabling

3.1Cabling of Subscriber Lines

Before the IP DSLAM is mounted the connections between the Line MDF and the Exchange MDF have to be rewired. The wires are disconnected, and then reconnected through typically a Broadband MDF and the EDA System according to planning.

3.1.1Cabling Lines

The following description explains how to rewire the connections between the Line MDF and Exchange MDF through the EDGE connectors.

Figure 2 on page 4 shows the subscriber line connections through the EDGE connectors both for exchange and line side.

12 Lines to the Exchange	12 Subscriber Lines
	to the Line MDF
MDF
Line L	Subscriber L
	Subscriber K
Line K
	Subscriber J
Line J
	Subscriber I
Line I
	Subscriber H
Line H
	Subscriber G
Line G
Line F	Subscriber F
	Subscriber E
Line E
	Subscriber D
Line D
	Subscriber C
Line C
	Subscriber B
Line B
	Subscriber A
Line A
Exchange EDGE Connector	Line EDGE Connector

Figure 2 Rewiring the Subscriber Line through EDGE Connectors

4 1/1531-HSD 101 41 Uen A 2004-01-30