Ericsson EUB-9701 EXT2 user manual EUB-9701 Wireless N USB adapter Version

Page 23

EUB-9701 Wireless N USB adapter

Version 1.3

Enable TCP Window Size :.( When checked, the reception speed will improve.)

Fast Roaming at ___ dBm: Will enter roaming mode when dBm reaches defined level.

CCX 2.0: Open CCX (supports Cisco Compatible Extensions function). Check it after making sure the Wireless AP supports it.

Turn on CCKM: Open CCKM function (Cisco Key Management).

Enable Radio Measurements: Open the function of CCK Monitor AP Channel.

Non-Serving Channel Measurements: Select and start to monitor the channels on which the AP is not transmitting

Turn off RF: Disable wireless radio.

Turn on RF: Enables wireless radio.

[Apply]: Click this when finish the settings.

23

Image 23

Contents EUB-9701 EXT2 Table of Contents Revision History Introduction FeaturesPackage Contents System Requirements InstallationEUB-9701 Wireless N USB adapter Version EUB-9701 Wireless N USB adapter Version Verify installation Setup Network Configuration MS WinXP Select the General tab Setup Wlan EnGenius Config-Utility Ssid Setting WEP Setup Network security WEP, WPA…Setting WPA WPA and WPA2 Setting the Authentication and Security Adding Profiles EUB-9701 Wireless N USB adapter Version WPS Configuration 12 QoS Advanced Settings EUB-9701 Wireless N USB adapter Version Statistics Link Status About Uninstalling EnGenius Utility/Driver Select Remove All EUB-9701 Wireless N USB adapter Version EUB-9701 Wireless N USB adapter Version Appendix a Driver Installation for Windows Vista EUB-9701 Wireless N USB adapter Version Click Install this driver software anyway Wait a moment Finish install driver. Click Close RF Information Appendix B SpecificationsFederal Communication Commission Interference Statement Industry Canada statement