Ericsson EUB-9701 EXT2 user manual Federal Communication Commission Interference Statement

Page 37

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.

Note to US model owner: To comply with US FCC regulation, the country selection function has been completely removed from all US models. The above function is for non-US models only.

Image 37
Contents EUB-9701 EXT2 Table of Contents Revision History Introduction FeaturesPackage Contents System Requirements InstallationEUB-9701 Wireless N USB adapter Version EUB-9701 Wireless N USB adapter Version Verify installation Setup Network Configuration MS WinXP Select the General tab Setup Wlan EnGenius Config-Utility Ssid Setting WEP Setup Network security WEP, WPA…Setting WPA WPA and WPA2 Setting the Authentication and Security Adding Profiles EUB-9701 Wireless N USB adapter Version WPS Configuration 12 QoS Advanced Settings EUB-9701 Wireless N USB adapter Version Statistics Link Status About Uninstalling EnGenius Utility/Driver Select Remove All EUB-9701 Wireless N USB adapter Version EUB-9701 Wireless N USB adapter Version Appendix a Driver Installation for Windows Vista EUB-9701 Wireless N USB adapter Version Click Install this driver software anyway Wait a moment Finish install driver. Click Close RF Information Appendix B SpecificationsFederal Communication Commission Interference Statement Industry Canada statement