D-Link DCM-202, USB/Ethernet Broadband Cable Modem manual Important Note

Page 38

Governing Law: This Limited Warranty shall be governed by the laws of the State of California. Some states do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the foregoing limitations and exclusions may not apply. This limited warranty provides specific legal rights and the product owner may also have other rights which vary from state to state.

Trademarks: D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered trademarks are the property of their respective manufacturers or owners.

Copyright Statement: No part of this publication or documentation accompanying this Product may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior

notice. Copyright© 2002 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

CE Mark Warning: This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compli-

ance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference re- ceived, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of about eight inches (20cm) between the radiator and your body.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

38

Image 38
Contents Link DCM-202 Contents Package Contents System Requirements for Configuration Before installing the modem Local Cable Network ServicePrepare Your Workspace for the Cable Modem Installation Serial Number S/N RF and ETH MACPrepare Your Workspace for the Cable Modem Installation Introduction Features Decide Which Installation Process to UseInstalling the Cable Modem Using the Ethernet Port Verify the TCP/IP Protocol Configuration Configuring TCP/IP on the Windows 2000 Operating Systems To configure TCP/IP on your Windows 2000 PCTo configure TCP/IP on a Macintosh Configuring TCP/IP on a Macintosh ComputerTo configure TCP/IP on your Windows NT 4.0 PC Problem I cannot access my e-mail or Internet service Connecting the Cable ModemTroubleshooting the Ethernet Installation Problem I cannot access my e-mail or Internet service Click Command Prompt Installing the Cable Modem Using the USB Port Installing the Hardware Cable Modem and Power Adapter To install the hardwareInstalling the Software Drivers Installing the Software Drivers Windows 98 OSInstalling the Software Drivers Windows 98 OS \Drivers\Installing the Software Drivers Windows 98 OS Installing the Software Drivers Windows 2000 OS \Drivers\ Installing the Software Drivers Windows 2000 OS Installing the Software Drivers Windows Me OS Add New Hardware Wizard screen appearsInstalling the Software Drivers Windows Me OS Troubleshooting the USB Installation Click Control Panel Page Cable Modem Front and Rear Panels Front Panel LEDsCable PowerWhat the LED Activity Means StatusBack Panel Connectors Reset PowerTechnical Specifications InterfaceOSS LED Link Technical Support over the Internet Contacting Technical Support Link Technical Support over the Telephone 877 Warranty Page Important Note Registration
Related manuals
Manual 7 pages 3.15 Kb Manual 39 pages 34.47 Kb