IRIS DC1100E manual Iris Uplink Connection, Connections with an external Upconverter

Page 20

UPLINK	RX1
	RX1		TX RF ON
CONSOLE	PWR	ACT	TX RF ON

IRIS Rear Panel

RF OUT

IF IN

Upconverter Rear Panel

Diplexer

TO DISTRIBUTION

Figure 6 Connections with an external Upconverter

IRIS Uplink Connection

IRIS Uplink port is a 10/100 Ethernet port, which has to be connected to back office network switch or the uplink device such as satellite or DSL modem. When connecting to a switch a straight Cat5 Ethernet cable will be required. When connecting to a DSL modem or satellite modem you might need to use an orange colored cross over cable.

The link light on the IRIS Uplink port will light up when you have used the right cable required to connect to the switch or the uplink device.

	UPLINK	RX1
				TX
	CONSOLE	PWR	ACT
				RFON
	CAT5	IRIS Rear Panel

Connect to Switch or

Uplink Device

Figure 7 IRIS Uplink Connection

Coaxial Networks, Inc.

Page 20 of 60

Image 20

Contents Iris DC1100-UG RevisionThis page intentionally left blank Table of contents Coaxial Networks, Inc Table of Figures This page intentionally left blank Copyright 2001-2005, Coaxial Networks, Inc Software LicenseLimited Warranty General Provisions Coaxial Networks, Inc Introduction Key BenefitsInstallation Requirements Package ContentsIris Rear Panel Connections Iris Rear PanelIris Front Panel Mounting the Iris UnitMounting Flat on Wall Attaching mounting braces for flat wall mountCoaxial Networks, Inc Setup Connecting Your Iris DC1100 Configuring Your IRISDC1100 Checking Conditions Prior to System StartupCoaxial Cable Specifications Cable Network Diagram ConnectionsIris Connections with Integrated Upconverter Iris Connections with an external UpconverterIris Uplink Connection Connections with an external UpconverterLogging into Iris ConfigurationConfiguring Iris Connecting using Web Interface Web LoginConfiguring TCP/IP parameters Iris ConfigurationConfiguring Iris in Router mode Save and rebootConfiguring Iris in Bridge mode Network SetupBridge mode setup Bridge Mode Configuration Configuring Downstream RF Settings Downstream RF SettingsConfiguring Upstream RF Settings Upstream RF SettingsCreating Class of Service Profiles Class of Service CreationCoaxial Networks, Inc Adding Cable Modems Controlling Cable Modem AccessEnabling conditional access Saving Cable Modems List Cable Modem SubscriptionCoaxial Networks, Inc Iris CLI interface using Telnet Connecting from the cable interfaceConnecting from serial console Telnet to IrisHelp command LoggingPreg or preg verbose command Psid commandCount command Pcpe commandConfigcm command Rcount command Ver commandReboot command Shutdown commandUpcon command Coaxial Networks, Inc This page intentionally left blank Application Notes Network traffic between cable clientsAllowing PPPoE traffic across Iris Static IP MappingAssigning a reserved IP address to the CPE Assigning additional IP addresses to the uplink InterfaceChannel Frequency Chart Ntsc Channel Frequency Chart in MHz DocsisCoaxial Networks, Inc Coaxial Networks, Inc Coaxial Networks, Inc PAL Frequency Allocation EuroDOCSIS Channel Center Frequencies for Selected PAL SystemsChannel Center Frequencies for System G Hyperband Coaxial Networks, Inc Channel Center Frequencies for System G and D Regulatory Compliance Agency StandardsSpecifications Ietf MibsInsert/Overtype Mode Command Mode Entering Insert ModeVI Visual Editor EnteringCoaxial Networks, Inc Miscellaneous Ex Commands Ex syntax Some commands areVi environment variables File Saving and LoadingExamples