psid | print MacAddress to Sid map |
preg | print CM registration status |
pcpe | print CM and associated CPE |
config_cm <ifile> <ofile> | generate CM config file |
(q)uit | quit command interpreter |
system | go to the system prompt |
reboot | restart the system |
shutdown | shutdown the system |
! | repeat last command |
tty | displays the terminal name |
passwd | changes password for iris |
upcon <cmd> | upconveter config command, upcon ? for list |
setupl | setup uplink (en2) IP network parameters |
setif <if> <ip> <netmask> | sets interface ip address and netmask |
showif [if] | show interface parameters, en1, en2 |
dhcp <cmd> | dhcp server command, dhcp ? for list |
bridge [on/off] | Enable or disable briding mode for IRIS |
addcm <mac_address> [comment] .. | Add CM to subscribed list |
delcm <mac_address> | Delete CM from subscribed list |
savecm | Save subscribed CM list |
psub | Print subscribed CM list |
punsub | Print unsubscribed CM list |
Figure 21 List of CLI commands
“preg” or ”preg verbose” command
The “preg” command displays you a list of MAC addresses of cable modems that have communicated to IRIS, their SID (service identifier) and the current registered state.
IRIS>preg
Registered CMs
MAC | PSID | USID | STATUS |
00:0b:06:9f:a7:fe | 0x0002 | 0x01 | Yes |
00:10:95:1b:e1:c5 | 0x0001 | 0x01 | Yes |
00:30:eb:bc:0c:a5 | 0x0004 | 0x01 | Yes |
00:90:83:8c:58:23 | 0x0003 | 0x01 | Yes |
00:e0:ca:00:c1:9c | 0x0005 | 0x01 | Yes |
Total(5), Yes(5) No(0) |
|
| |
Unsubscribed CMs
Total(0)
Figure 22 List of registered cable modems
“psid” command
The “psid” command displays you a list of MAC addresses of cable modems or PCs connected to the cable modems. Each cable modem and PCs connected to them will have unique MAC address but same SID or service identifier.
IRIS>psid
MAC address to SID map:
MACSID
Coaxial Networks, Inc. | Page 37 of 60 |