Now that you’ve gotten everything hooked up and in place, the fun begins! We advise that you read through this section once or twice for familiarity with the process. You may also want to refer back to the Programming and Quick Reference Guide table to pencil in selected programming values for each feature you wish to control.
The first thing you should do is place a local call to your best buddy. Ask him or her to lay their phone receiver down for a moment.... but don’t
hang it up. This will keep you from incurring any long distance phone charges or "freaking out" the local phone company with all the numbers you will dial to program The Stick.
After placing a call to your friend, wait at least five seconds before
proceeding. First, DIAL "# # 7 7” on your telephone key pad. The LED light will begin blinking rapidly. Immediately listen for three rapid high-
pitch beeps in your handset. Three
you have entered the programming mode and may “PROCEED”.
At this time, you should enter the Register Number of the feature you wish to program and proper value(s). If the proper register number and programming value(s) are entered, The Stick will answer with a high- pitch tone immediately followed by a
If the numbers you enter are invalid (either for the Feature Register or program value), The Stick will respond with a single
In either case, three rapid
you to “PROCEED”. At this time you may either access and program a new feature register or correct the previous attempt by entering new numbers.
9