Multi-Link Voice/Fax/Modem Call Processor manual Do’s and Don’ts Of SAC Programming

connected to The Stick. SAC’s are programmable (using a touch tone phone only) up to 4 characters long- digits 0 through 9 and symbols * (star) and # (pound). The Stick will not detect SAC’s dialed from “calling” pulse phones- only from touch tone phones. Call transfers dialed by a pulse phone are limited to phones hooked to or on the same line as The Stick and are limited to transfer to the “FAX” port only. The pulse dial SAC for this is fixed at “2”. You must also have the “Pulse Detect” feature on if you use a pulse dial phone to transfer a call.

Do’s and Don’ts Of SAC Programming

•1 Digit Security Access Codes ARE NOT recommended. (Refer to “Programming” Section, page 9).

•DO NOT use the codes " 9 " "#","# #", or anything beginning with "9" or "##" These codes are reserved for the “Call Grab” feature and

programming access to The Stick, respectively.

•DO NOT select an access code that may be the first part of a dialed number or the control code of your answering machine.

Factory preset Security Access Codes are as follows:
	Touch Tone	Pulse Dial
VOICE 1 and VOICE 2 Ports-	*1	None
FAX Port-	*2	2
MODEM Port-	*3	None

Pulse Detection-The Pulse Detection feature, when activated, allows The Stick to detect the factory preset code “2” and “Call Grab” preset code "9" when dialed from a pulse dial phone. The factory preset for this feature is “off.”

Rings To Answer-This feature directs The Stick to answer an inbound call after a programmed number of rings (0 to 10 rings) from the phone company. If RTA is programmed to “O”, The Stick will answer the call during the first ring. Extension phones elsewhere in your location will only “chirp” the first ring before going quiet. If the RTA is greater than

"0 " , The Stick will allow all incoming calls to ring extensions and devices connected to the ports labeled VOICE 1 and VOICE 2 for the programmed number of rings. Factory preset is 0 rings.

3