Cabling
Table 1. Cabling Procedure
Step Procedure
1Connect one end of the power supply to a live AC outlet and connect the other end to the ProxyServer as shown in Figure 3. The power connector is a
2Connect the ProxyServer to a PC by using the short
RJ45 to DB25 (female) cable provided with your unit. Plug the RJ45 end of the cable into the Command Port of the ProxyServer and the other end into the RS232 cable from the PC serial port. See Figure 3.
3To make the network connection, connect one end of an RJ45 (UTP) cable to the 10
4Connect one end of an RJ45 cable to the ISDN connector on the back of the unit and connect the other end to the ISDN Telephone Network (Telco wall jack) as shown in Figure 3.
5Turn on power to the ProxyServer by placing the ON/OFF switch on the back panel to the ON position.
Wait for the Fail LED on the ProxyServer to go OFF before proceeding. This may take a couple minutes to go off.
At this time your ProxyServer is completely cabled. Proceed to the next section to load your ProxyServer software.
5