Call Control Parameters,  Voice Spid

Software

Note: For DMS-100 switches, any ASCII character except the underline (_) character is valid. For NI-1 and AT&T switches, only the digits 0-9 are valid.

Voice SPID________________________________________

The voice SPID is assigned by the local phone company and is for the specific BRI line to which the ProxyServer will be at- tached. The voice SPID string can have up to 20 characters. The data SPID is not used if the switch type is set to NET3.

Note: For DMS-100 switches, any ASCII character except the underline (_) character is valid. For NI-1 and AT&T switches, only the digits 0-9 are valid.

Data Directory Number______________________________

The data Directory Number (DN) is a telephone number that is assigned to the ProxyServer at subscription time by the ISDN service provider. The DN is a string of up to 24 characters; valid characters are 0-9, the * character, and the # character.

Voice Directory Number______________________________

The voice Directory Number (DN) is a telephone number that is assigned to the ProxyServer at subscription time by the ISDN service provider. The DN is a string of up to 24 characters; valid characters are 0-9, the * character, and the # character.

Call Control Parameters

Persistent DTR Dialing______________________________

A high DTR (Data Terminal Ready) signal on the Command port indicates that your computer or terminal is ready to communi- cate with your ProxyServer. DTR normally goes high when a communication program starts or is ready to dial. Persistent DTR dialing enables the ProxyServer to automatically redial the number stored in memory location 0 whenever DTR is high and the serial port does not have an active call. You may enable or disable this feature.

Calling Line Identification___________________________

Identifies whether the two endpoints of a connection are en- abled or disabled. Since RING messages only appear for ISDN data calls, the CLI feature does not define a means of