Introduction, Check the contents in the package

Introduction

The Model CD-1A is designed exclusively for the VF160 digital multitracker. By installing the CD-1A to the VF160, you can;

*save or load your song data to or from a CD-R/CD-RW disc,

*make your original audio CD using materials recorded on the VF160, or

*load song data from an audio CD.

This manual describes how to install the CD-1A in the VF160. See the VF160 operation manual for details about how to save/load song data or how to make an audio CD.

<Check the contents in the package>

* a CD-RW drive unit

This product includes the following in the package.

If you cannot find all of the contents listed above, please contact your dealer or local Fostex sales office.

*two screws for mounting the drive

*a blank panel

<Usable discs>

With the CD-1A, you can use discs of fol- lowing types.

<CD-R discs>

Can be used for saving or load- ing song data, as well as mak- ing an audio CD.

Note that you can record data to a CD-R disc only once. You cannot record data to a disc which has been recorded be- fore.

<CD-RW discs>

Can be used for saving or loading song data, as well as making an audio CD.

You can record or erase data to a CD-R disc as many times as wish.

As these are read-only discs, you only can use them for loading track data to the VF160.

See the VF160 operation manual for details about how to save/load song data or how to make an audio CD.

•When handling a disc, be careful not to dirty or scratch the surface of the disc.

We recommend that you hold the disc with your finger on the disc edge and center hole.

•Do not stick any paper, etc. on the label side. Also do not scratch the label side, which may cause problems during playback or recording. Use only a felt pen or equivalent for writing any memo on the label side. Using a ball-point pen, pencil, etc. that has a hard tip may damage a disc.

•Never use a warped or chipped disc, which may damage the CD-RW drive.