3
Use two screws supplied with the
Tighten the screws with a screwdriver.
Opening/closing the tray
•To open the tray, press the eject switch lightly.
Pressing the switch will open the tray slightly. Then pull out the tray gently by hand to fully open it.
screw position | screw position |
4Use the screw you removed in step 1 to fix the blank panel supplied with the
panel.
Slant the panel slightly when inserting the panel inside the unit.
Eject switch
The tray slightly opens.
lens
Use the screw you re- moved in step 1 to fix the blank panel.
5Connect the power cord of the VF160 and turn on the power.
Make sure that the VF160 starts up, and the LED indicator on the front panel of the CD- 1A blinks for a few seconds then turns off.
Wait until the VF160 display changes to the Normal display from the
Pull out the tray to fully open it.
<Caution!>
Do not touch the lens when pulling out the tray, doing so may damage it and may cause a malfunction.
•To close the tray, push the tray inside by hand until locked.
Push until it is locked.
4