SBC comm 52609x02 guide

6-2 Plug the power cable into the DSL modem and an electrical outlet.

6-3 Connect the data cable to your telephone jack and your DSL modem. There should NOT be a filter between the data cable and the wall jack.

6-4 Connect the Ethernet cable to the Kingston® Ethernet Port or the built –in Ethernet Port on the back of your PC and to the Ethernet Port on the back of your DSL modem.

6-5 Turn the DSL Modem power switch ON.

6-6 The Sys, ATM, Enet and DSL lights should all turn solid green within two minutes.

•If the Sys or ATM light does not turn solid green, check your power cable. Are you connected to a live electrical outlet? Are connections secured? Is the modem turned on?

•If the Enet light does not turn solid green, check your Ethernet connections. Are they secure? Is the PC turned on?

•If the DSL light does not turn solid green:

•Verify that there is NO in-line filter on the data cable from your DSL modem to the telephone jack.

•Try another telephone jack in your home.

•Turn off the modem, reboot the computer and then turn the modem back on.

•Verify that you are installing your DSL equipment AFTER the “Service Completion Date” given to you when you ordered your DSL Internet Service.

6-7 Proceed to Step 7 by clicking Next on the DSL Modem Setup screen.

Installation Guide for Customer Self-Install: Efficient Networks® 5260, Windows 95/98/Me/2000	Page 18
©2001 SBC Advanced Solutions, Inc. All rights reserved.