45.Secure the BUS cable connector to the vehicle harness 135 mm away from the vehicle harness clip with one long wire tie. Attach the BUS cable to the corner of the body panel with one cushion tape in the area shown.
CD CHANGER
BUS CABLE
LONG WIRE TIE
| 135 mm |
CUSHION TAPE | BUS CABLE |
Secure to the | CONNECTOR |
corner. |
|
46.Using a utility knife, cut out the marked areas from the back of the left trunk side board. First cut out areas A, B, and C, then area D.
A
BACK OF LEFT TRUNK
SIDE BOARD
B
C
D
Cut across.
47.Reinstall the left trunk side board on the CD changer brackets, and install the two clips.
BASE
BRACKET
CD CHANGER
BASE BRACKET
LEFTTRUNK | CLIPS |
SIDE BOARD |
|
48.Reinstall the trunk box, and check that the CD can be loaded and ejected properly by opening the lid of the CD changer.
49.Plug the BUS cable connector, the radio connector, and the antenna lead into the rear of the radio.
RADIO
BUS CABLE
CONNECTOR
50.Check that all wire harnesses are routed properly and all connectors are plugged in.
51.Reconnect the negative cable to the battery.
52.Reset the clock and the radio station presets.
53.Reinstall all removed parts.
54.Check the operation of the CD changer as described in the Owner's Manual supplied.
55.Put the CD Changer Owner's Manual and the shipping screws (removed in step 26) in the glove box for your customer.
10 of 10
AII 23268 (0110) | © 2001 American Honda Motor Co., Inc - All Rights Reserved. |