Honda Power Equipment Illustration of the CD Changer Installed on the Vehicle

Page 2

TOOLS AND SUPPLIES REQUIRED

#2 Phillips screwdriver Flat-tip screwdriver Stubby Phillips screwdriver 10 mm Combination wrench Ratchet

10 mm Socket Diagonal cutters Utility knife Tape measure Gloves

Illustration of the CD Changer Installed on the Vehicle

CD CHANGER (sold separately)

BUS CORD

INSTALLATION

Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle.These procedures should not be attempted by “do-it-yourselfers.”

1.Write down the frequencies for the radio station preset buttons.

2.Disconnect the negative cable from the battery.

3.Remove the two bolts that fasten the glove box, and remove the glove box.

GLOVE BOX

BOLTS

4.Remove the center lower cover by removing the two screws, releasing the 11 clips, and disconnecting the connector.

SELF-TAPPING

CLIP

SCREW

 

CENTER

LOWER

COVER

SCREW

CONNECTOR

2 of 10

AII 23268 (0110)

© 2001 American Honda Motor Co., Inc - All Rights Reserved.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Installation Illustration of the CD Changer Installed on the Vehicle Remove the drivers door sill trim four retaining clips Routing the BUS Cable Remove the cargo box Speaker Holderclip Screw Floor Installing the CD Changer CD Changer Trim SELF-TAPPING Screws Rear Base Front EPT Bracket CD Changer BUS Cable Long Wire TIE
Top Page Image Contents