Rear Base Front EPT Bracket | Honda Power Equipment CD Changer

38.Cut one piece of EPT sealer in half. Attach the halves to the rear clip nuts you installed in step 36.

EPT SEALER

EPT SEALER (Cut in half.)

REAR BASE	FRONT		EPT
BRACKET	BASE		EPT
6 x 16 mm	BRACKET	6 x 16 mm	SEALER
		6 x 16 mm

WASHER-BOLT	WASHER-BOLT

39.Position the rear base bracket on the clip nuts, and install two 6 x 16 mm washer-bolts. Tighten the bolts securely.

40.Position the front base bracket on the clip nuts and install two 6 x 16 mm washer-bolts. Tighten the bolts securely. Attach one EPT sealer over the head of the lower bracket bolt.

41.Push the clip of the vehicle wire harness removed in step 35 into the hole in the rear base bracket.

REAR BASE

BRACKET

VEHICLE

HARNESS

CLIP

42.Position the CD changer on the studs extending from the front and rear base brackets, and install the four flange nuts. Install the CD changer first on the front bracket, then the rear bracket.

FRONT

BRACKET

STUDS

REAR

BRACKET

STUDS

CD CHANGER

FLANGE

NUTS

43.Reinstall the relay that was removed in step 20.

44.Plug the BUS cable connector into the CD changer.

BOLT (reused)

VEHICLE RELAY

BUS

CABLE

CD CHANGER CONNECTOR

AII 23268 (0110)

9 of 10