Fellowes MS7CS manual Operation, Troubleshooting, Maintenance, Warranty

Page 2

ENGLISH

Model MS7Cs

OPERATION

Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.

Shredder head

Sheet capacity icon

Paper entry

Indicator lights Ready (green)

Overheated

Window

Pull-out bin

SafeSense® Technology Card/CD entry See safety instructions below

SafeSense® (yellow)

SafeSense® override switch

Active

Not Active

Disconnect power switch

Continuous operation: 8-10-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond

8-10-minutes will trigger a cool down period to resume operation.

PAPER

 

Press Auto-On (I)

 

Feed into paper entry

 

 

 

and release

Set to Off (O)

CARD/CD

 

Set to Off (O)

and plug in

 

 

and unplug

 

Press Auto-On (I)

Hold card/CD at edge

Feed into card/CD entry

 

 

 

and release

Control switch

Auto (I) Off (O)

TROUBLESHOOTING

Breakthrough Safety Technology! SafeSense® stops shredding when hands are too close to the opening.

— To Test SafeSense® Technology

Press Auto-On (I)

Touch test area

Sensor lights up

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Paper jam: Set to Off and empty bin. Replace bin and follow any or all of the below procedures.

 

Shredder doesn’t start:

 

 

 

 

 

 

 

Yellow - SafeSense® active

 

 

 

 

 

Yellow flashing - SafeSense® not active

 

 

 

 

 

Make sure bin is pushed in

Press and hold

Alternate slowly back and forth

Set to Off (O)

Gently pull uncut paper

Press and hold

Wait for motor to cool down

Reverse ( )

 

and unplug

from paper entry. Plug in.

Reverse ( )

 

 

ATTENTION: If the SafeSense® light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense® feature. (See SafeSense® instructions below.)

Sensor light illuminated–paper jammed

CAPABILITIES

Will shred: Paper, credit cards, CD/DVDs, staples and small paper clips

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than noted above

Paper shred size:

 

Confetti-Cut

5/64” x 5/16” (2 x 8mm)

Maximum:

 

Sheets per pass (Confetti-Cut)

7*

Cards/CDs per pass

1

Paper width

8.75”/220mm

Card/CD width

5”/125mm

Continuous operation

8-10 minutes

SafeSense® paper jam: If the SafeSense® feature activates (SafeSense® light remains on) to cause the user to think the shredder has jammed when it has not, use theOverride Switch to deactivate the SafeSense® feature and clear the paper. Warning – when switch is in override position, the SafeSense® light will flash and the SafeSense® feature will NOT function. Once the paper is cleared, reset the SafeSense® feature.

SafeSense® override switch

Active

Not active

Card/CD shred size:

 

Strip-Cut

5/16” (8mm)

*20lb., 8.5”x11” (75g) paper at 120v, 60 Hz, MS7Cs–4.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 25-50 paper passes; 25 cards; 10 CDs.

Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

MAINTENANCE

Run regularly in reverse for one minute

Oil when bin is full, or

Follow oiling procedure below and repeat twice.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

immediately, if:

Capacity decreases

Motor sounds different, or Shredder stops running

*Apply oil

Press forward

Shred one sheet

Press and hold Reverse ( )

across entry

 

 

2-3 seconds

• Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc.

– away from shredder openings. If object enters top opening,

• Never use aerosol, petroleum based or other flammable products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.

WARRANTY

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006

 

 

switch to Reverse (

) to back out object.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Avoid touching exposed blades under Confetti-Cut shredder head.

Use only designated entry for cards/CDs. Keep finger away from CD hole.

2

• 7 sheets per pass to avoid jams.

The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.

Paper and Card/CD cannot be shredded at same time.

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from

WARRANTY,

INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,

defects in material and workmanship for 5 years from the date of purchase by the original consumer.

IS

HEREBY

LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE.

Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1

In

no event

shall Fellowes be liable for any consequential or incidental damages attributable to

year from the date of purchase by the original consumer. If any part is found to be defective during the

this product.

 

warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and

This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid

expense, of the defective part.

worldwide, except where different limitations, restrictions, or conditions may be required by local law.

This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

For more details or to obtain service under this warranty, please contact us or your dealer.

3

Image 2
Contents Fellowes Australia Canada México United StatesWarranty TroubleshootingMaintenance OperationEntretien EmploiDépannage GarantieMantenimiento Solución DE ProblemasFuncionamiento Garantia