Precor Maintenance and Troubleshooting, Cleaning the 719e Climber, Changing the Batteries

Maintenance and Troubleshooting

The 719e climber requires very little maintenance. The only maintenance you need to do periodically is to clean the climber. You will also need to change the batteries when they wear down. Instructions for these procedures are provided in this section.

If you encounter problems with the 719e climber, refer to Troubleshooting Tips in this section for help.

Cleaning the 719e Climber

Clean the 719e climber periodically with mild soap and water or a general household cleaner. Wipe the surface of the electronic console with a damp sponge or soft cloth. Dry with a clean towel. Do not pour or spray liquids on the electronic console.

Changing the Batteries

The 719e climber comes with two “AA” alkaline batteries installed. When your electronic console no longer shows a digital readout or the count becomes erratic, you need to change the batteries.

To change the batteries:

1.Press down on the latch to open the door on the side of the electronic console and replace the old batteries with two new “AA” alkaline batteries. The entire display lights up momentarily, the console beeps twice, and then the display shows “002.”

2.Press the MODE key once. The display shows “001.”

NOTE: If you happen to press the MODE key more than once, do not worry. You can scroll through all the options on the display by pressing MODE repeatedly until “001” appears. Pressing START/STOP backs up the display one option.

3.Press RESET to activate the climber.

4.If you have not already done so, close the door on the side of the electronic console display. You can now work out on the climber.

page 17