Frame | Precor 719e specs

Diagram 6

Connect resistance cylinders to

frame.

Plastic collar

Upper axle

Plastic bushing

Washer

Resistance cylinder

Upright support (long tube)

7.Connect Resistance Cylinders to Upright Support. (Diagram 6) Slide the plastic collar (G) over the upper axle, with the straight bevel toward the frame. Lift up on the stair arm until you can push the top of the resistance cylinder onto the upper axle, then attach the cylinder to the axle using a bushing (L), washer (C), and button-head bolt (D). Repeat step 7 for the other resistance cylinder.

Diagram 7

Install handrail console and insert handrails into clamps

Upper handrail clamp

Upper handrail console

Electronic console mounts

Handrail (long, straight section)

Upright support (long tube)

Lower handrail clamp

8.Install Upper Handrail Console. (Diagram 7) Position the upper handrail console on top of the long tube. Pull the excess reed switch cable up through the large hole in the handrail console and tape it to the top of the console. Locate two button-head bolts (D) in the hardware kit and place a small, black washer (B) on each bolt. Secure the handrail console to the frame by inserting the bolts and washers through the top of the handrail console and into the upright support.

9.Install Handrails. (Diagram 7) Loosen the bolts in the handrail clamps using the hex key provided. Orient the handrails so that the longer, “straight” section of the handrails is positioned on top. Place the handrails in the upper clamp. Rotate the lower portion of the handrails into position and insert each handrail into the lower clamp. Finger-tighten the bolts into both clamps.

page 8