HSM HSM FA 400.2 manual Greasing the drive chains and cogs twice yearly, Tightening the feed belt

Page 11

FA 400.2

Greasing the drive chains and cogs (twice yearly)

• Switch off the shredder.

• Pull out the power plug.

Remove the tray and the cover panels.

Grease the cogs and the drive chains from the motor to the cutting apparatus, the cut- ting block to the feed belt and the cutting block to the regulating roller. Recommended lubricating grease: K2K in accordance with DIN 51502/DIN 51825

Put the side cover panels and the tray back on.

Tightening the feed belt

The feed belt should not slip when loaded with material.

• Switch off the shredder.

You must check that the feed belt runs straight:

Switch on the shredder and let it run for

10 minutes. During this time, the feed belt must run in the middle of the snub roller. If it slips to the left or right edge, you must alter the setting of the snub roller.

Checking the feed belt for wear

The surface of the feed belt can become worn after long periods of use. If you can see the fabric inlay in the belt, it must be replaced. Please notify our customer service.

Cleaning the shredder:

Switch off the shredder and disconnect the power plug.

Only use a soft cloth and mild soapy water for cleaning. Never use scouring agent, cleaning fluid, petroleum or thinners.

1 2 3

1 2 3

Loosen the hex nuts

(1)on the left and right sides of the snub roller.

Loosen the lock nuts

(2)of the tensioning bolts (3).

Tighten the feed belt evenly using the tensioning bolts.

Note:

Only tighten the feed belt until it stops slip- ping. The feed belt bearing may be dam- aged if it is tightened too much.

Tighten the hex nuts on the snub roller and the lock nuts on the tensioning bolts again.

0702

11

Image 11
Contents English HSM FAContents Main switch only Solo-version Proper use, warrantySafety instructions Operating controls for your safetyOverview HSM FA 400.2 Combi version DimensionsHSM FA 400.2 Solo version Combination version Transportation, installationSolo machine Attaching the waste bag Solo version Start-up, inspecting the safety devicesSwitching on the shredder Operating and display elements on the keypadShredding material Inspecting the safety devicesInspecting the door switch Checking the emergency stop buttonMalfunctions Checking the chain tension twice yearly Maintenance and careCleaning the cutting block Strip cut machines 1 x daily Cross cut machinesChecking the feed belt for wear Cleaning the shredderGreasing the drive chains and cogs twice yearly Tightening the feed beltTechnical data Scope of supply, accessoriesElectric wiring diagrams 0702 0702 Combination 0702 0702 0702 Declaration of Conformity