HSM HSM FA 400.2 manual Transportation, installation, Solo machine, Combination version

Page 6

FA 400.2

5. Transportation, installation

Place the shredder in its packaging on a smooth, level surface.

Remove the packaging.

If you need to move the shredder through narrow doors, you can wait until it is at its final location before fitting the loading tray. Without the tray, the machine is only 805 mm wide.

When moving the shredder, note that it may topple over.

The shredder can be moved on its rollers.

If using a forklift to transport a Solo machine, you must first remove the waste trolley. Then you can push the forks under the machine from the left or right side and lift it up.

Fitting the loading tray:

Fasten the tray on both sides at the top with the Phil- lips screws (1) and at the bottom with the 2 nuts (2).

1

2

The shredder may only be placed in dry rooms on a hard, level floor – not on carpets. The floor load on each roller is approximately 107 kg.

Place the machine in such a way that the power plug is easily accessible and the ventilation slots are free.

Solo machine:

-Lock the front castors by pressing down the brake lever.

-Connect the power plug of the shredder to the 32A CEE mains socket.

Combination version:

-Push the shredder up to the baling press until the press and the outlet chute of the shredder touch.

-Bolt the shredder and the baling press together.

-Lock the front castors by pressing down the brake lever.

-Connect the power plug of the shredder to the com- bination socket of the baling press.

The machine must be connected to a power source which meets the specifications on the nameplate.

Make sure the power cable is unobstructed and that nobody can tread on it.

No platforms or other raised surfaces may be placed near the shredder if they encroach on the specified safety clearances.

6

0702

Image 6
Contents HSM FA EnglishContents Operating controls for your safety Proper use, warrantySafety instructions Main switch only Solo-versionOverview Dimensions HSM FA 400.2 Solo versionHSM FA 400.2 Combi version Transportation, installation Solo machineCombination version Operating and display elements on the keypad Start-up, inspecting the safety devicesSwitching on the shredder Attaching the waste bag Solo versionChecking the emergency stop button Inspecting the safety devicesInspecting the door switch Shredding materialMalfunctions Cross cut machines Maintenance and careCleaning the cutting block Strip cut machines 1 x daily Checking the chain tension twice yearlyTightening the feed belt Cleaning the shredderGreasing the drive chains and cogs twice yearly Checking the feed belt for wearScope of supply, accessories Technical dataElectric wiring diagrams 0702 0702 Combination 0702 0702 0702 Declaration of Conformity