Sony NSP-100 manual Carrying Out Network Setup, Carrying Out RS-232C Setup

Operation

Settings selected in the “System Administrator Setup” screen

The settings selected in the “System Administrator Setup” screen are as follows. For details, see the respective pages.

Settings that	Function of setting	See page
can be
selected
“2. Network	This makes settings related to	20
Setup”	the network.
“3. RS-232C	This makes settings related to	20
Setup”	the RS-232C/GPI connector
	and plasma display.
“4. Menu	Select Japanese or English as	21
Language”	the menu language.
“5. Automatic	Select whether or not to	22
Delete”	enable the deletion of files for
	which an automatic deletion
	date is set.
“6. All Data	This deletes all data from the	22
Delete”	unit.
“7. Password	This sets a password.	22
Setup”

Carrying Out “Network Setup”

To make the settings relating to the network, use the following procedure.

1 In the “System Administrator Setup” screen, carry out any of the following.

•Press numeric button 2, then press the ENTER button.

•Using the v and V buttons, select “2. Network Setup,” and press the ENTER button.

The “Network Setup” screen appears.

To return to the “System Administrator Setup” screen

Carry out any of the following.

•Press numeric button 1, then press the ENTER button.

•Using the v and V buttons, select “1. Back to System Administrator Setup,” and press the ENTER button.

2 Carry out steps 4 to 8 of the procedure in “Starting Up and Initial Settings” (page 10).

3 Carry out any of the following.

•To exit the menu display, press the MENU button.

•To return to the “System Administrator Setup” screen, press numeric button 1, or using the v and V buttons, select “1. Back to System Administrator Setup,” and press the ENTER button.

To enable the new network settings, a message prompt appears, asking if you want to reset the unit.

4 To reset immediately, select “Yes”; to reset later, select “No.”

The initial screen or “System Administrator Setup” screen appears after a reset (for “Yes”) or immediately (for “No”).

Carrying Out “RS-232C Setup”

In the “RS-232C Setup” screen, you can select the following settings relating to control.

•Protocol control

Select this when using the dedicated control protocol.

•Maintenance

Select this when the RS-232C/GPI connector is to be used for maintenance.

•External device control

Select this when the RS-232C/GPI connector is to be used for control of an external device.

•Plasma control

Select this when using a plasma display.

Use the following procedure.

1 In the “System Administrator Setup” screen, carry out any of the following.

•Press numeric button 3, then press the ENTER button.

•Using the v and V buttons, select “3. RS-232C Setup,” and press the ENTER button.

20

System Administrator Setup