Memory and Performance
C o m m e n t s t o u c s - d o c f e e d b a ck @ c i s c o . c o m
Installing Memory
Only the DIMMs listed inTable 6 should be used. Memory must be installed in the order shown in Table 8 into the slots located in Figure 13. To install a DIMM into a slot in the B230 blade server, follow these steps:
Step 1 Open both DIMM connector latches. (See Figure 12, callout 1.)
Figure 12 Installing DIMMs in the Blade Server
1
2
2
1
3
3
199987
Step 2 Press the DIMM into its slot evenly on both ends until it clicks into place. (See Figure 12, callout 2.) Step 3 Press the DIMM connector latches inward slightly to seat them fully. (See Figure 12, callout 3.)
Memory and Performance
This section describes the type of memory that the B230 blade server requires and its effect on performance. The following topics are covered:
•Supported DIMMs, page 25
•Memory Arrangement, page 25
•Memory Performance, page 26
Cisco UCS B230 Blade Server Installation and Service Note
24 |
| |
|