C o m m e n t s t o u c s - d o c f e e d b a ck @ c i s c o . c o m
operating expenses. Among the I/O adapter options, and unique to the Cisco Unified Computing System, the Cisco UCS M81KR Virtual Interface Card (VIC) delivers up to 128 dynamic virtual adapters and interfaces, all integrated with Cisco UCS Manager and VMware vCenter Server. Incorporating Cisco
Figure 1 | Cisco UCS B230 |
1 |
| 4 | 6 | 9 | 10 | 15 | 13 | 14 |
| 12 | |||||||
|
|
|
|
|
|
|
| 199980 |
2 | 3 | 5 | 7 | 8 |
| 11 |
|
|
1 | SSD 1 activity LED | 9 | Beaconing LED and button |
|
|
|
|
2 | SSD 1 Fault/Locate LED | 10 | System activity LED |
|
|
|
|
3 | SSD sled in bay 1 | 11 | Blade health LED |
|
|
|
|
4 | SSD 2 activity LED | 12 | Reset button access |
|
|
|
|
5 | SSD 2 fault LED | 13 | Power button and LED |
|
|
|
|
6 | Ejector lever captive screw | 14 | Console connector |
|
|
|
|
7 | Ejector lever | 15 | Asset tab 1 |
8 | SSD sled in bay 2 |
|
|
|
|
|
|
1.Each server has a blank plastic tag that pulls out of the front panel, provided so you can add your own asset tracking label without interfering with the intended air flow.
Buttons
The Reset button is just inside the chassis and must be pressed using the tip of a paper clip or a similar item. Hold the button down for five seconds and then release it to restart the server if other methods of restarting are not working.
The beaconing function for an individual server can be turned on or off by pressing the combination button and LED or in UCS Manager. See Table 1 on page 3 for details.
The power button and LED allows you to manually take a server temporarily out of service but leave it in a state where it can be restarted quickly. Pressing the button for one second initiates a graceful shutdown, and pressing it for over 4 seconds initiates an immediate shutdown. If the desired power state for a service profile associated with a blade server or an integrated
Cisco UCS B230 Blade Server Installation and Service Note
2 |
| |
|