Compaq ML350 manual Memory Modules, To replace a memory module, reverse steps 2 through

Removal and Replacement Procedures

•Do not mix ECC and non-ECC DIMMs. If different types of DIMMs are mixed, the system will not properly function.

•A DIMM will only fit one way in the socket. Be sure to match the two key slots in the DIMM with the tabs in the DIMM socket. Push the memory module into the DIMM socket, ensuring that it is fully inserted and properly seated.

Memory Modules

CAUTION: Electrostatic discharge (ESD) can damage electronic components. Be sure that you are properly grounded (earthed) before beginning any installation procedure. Refer to “Electrostatic Discharge Information” earlier in this chapter.

To remove a memory module:

1.Complete the preparation procedures. Refer to “Preparation Procedures” earlier in this chapter.

2.Open the bezel door. Refer to “Bezel Door” earlier in this chapter.

3.Remove the access panel. Refer to “Access Panel” earlier in this chapter.

4.Press both memory module socket latches outward (1). This action releases the module and partially lifts it out of the socket.

5.Lift out the memory module (2).

IMPORTANT: A memory module can be installed only one way. Be sure to match the key sockets on the module with the tabs on the memory socket. Push the module down into the socket. Be sure that the module is fully inserted and properly seated.

1

2

1

Figure 2-27: Removing a memory module

To replace a memory module, reverse steps 2 through 5.

2-30 Compaq ProLiant ML350 Generation 3 Server Maintenance and Service Guide