B&B Electronics manual ESP904 Configuration, When the parameters have been set, click on Update

Introduction

ESP904 Configuration

Step 1: From the Windows Start menu, run the ESP Manager, then double click on the Searching Server icon.

Step 2: In the Search Setup box that appears, click on Search all reachable servers, and OK, to find the ESP904 on the network.

Step 3: A list of servers will appear in the Serial Server List window.

Figure 3. The ESP Manager Window

Introduction

Step 4: Double click on the first ESP904 port on the list (4000) to bring up the Server Properties configuration screen.

Figure 4. The Server Properties Window

Step 5: Change the Server Properties as required.

•Enable DHCP to allow the ESP904 to generate its own IP address

OR

•Obtain appropriate static IP, Netmask and Gateway addresses from your Network Administrator (recommended)

•Set the Console Mode property to RS-232 to match the serial device connected to the ESP904 serial port 1.

•Set Baud Rate, Data/Parity/Stop, and Flow Control to match the configuration of the serial device connected to the ESP904 serial port

Step 6: When the parameters have been set, click on Update.

Step 7: Click on Searching Servers, then re-enterServer Properties to confirm the changes.

Manual Documentation Number: ESP904-0504 Chapter 1 5 6 Chapter 1 Manual Documentation Number: ESP904-0504

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com	B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com	B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com