Compatible Systems manual DS3-Quad 10/100 Riop LED Patterns, Ethernet Traffic Indicators

Page 17

Chapter 4 - LED Patterns

DS3-Quad 10/100 RIOP LED Patterns

The following LEDs and light patterns provide information about the DS3-Quad 10/100 RIOP interfaces.

Scan from 1 to 3: Ethernet transmit packet

Scan from 5 to 3: Ethernet receive packet

Scan from 1 to 3: WAN transmit packet

Scan from 5 to 3: WAN receive packet

Link: The Link light indicates that there is a good connection to the hub.

Activity: The Activity light indicates that there is activity across the link.

100: The 100 light indicates that the interface is operating at 100 Mbps.

TX: WAN transmit packet

RX: WAN receive packet

Link: The Link light indicates that the interface is receiving signal from the upstream terminal.

Image 17

Contents DS3- Quad 10/100 Riop Installation Guide Page Quickstart Instructions Table of ContentsLED Patterns Shipping DefaultsQuickstart Configuration Network InstallationShipping Defaults Introduction to the DS3-Quad 10/100 RiopDS3 Line Connection Requirements Network InstallationConnecting the DS3-Quad 10/100 to the Ethernet Powering Up the Router Connecting the DS3-Quad 10/100 to a DS3 LineConnecting a Management Console Quickstart Instructions Ethernet Interface ConfigurationIP Protocol Required for IPDECnet Protocol IPX ProtocolAppleTalk Protocol Internal DS3 CSU/DSU Physical Communications Settings WAN Interface ConfigurationPPP Configuration Internal DS3 CSU/DSU Link ConfigurationFrame Relay Configuration Required for IP Unnumbered Interface Frame Relay Dlci MappingsRequired for IP Numbered Interface Suggested for IPX Saving a Configuration File to Flash ROM Smds ConfigurationLink Configuration Smds AddressingWAN Interface Shipping DefaultsEthernet Interfaces LED Patterns General IndicatorsRouter LED Patterns Over TempDS3 Indicators Ethernet Traffic IndicatorsEthernet Connection Indicators DS3 Connection Indicators