Compatible Systems 2200R manual Appendix a Shipping Defaults, Default Password, Ethernet Interface

Page 39

Appendix A - Shipping Defaults

33

Appendix A - Shipping Defaults

Default Password

•letmein

Ethernet Interface

IP Routing Defaults

•Off

IP Bridging Defaults

•On

•Address: 198.41.12.1

•Subnet Mask: 255.255.255.0

•Broadcast Address: 198.41.12.255

•IP RIP off

IPX Routing Defaults

•802.3 on, autoseeding

•802.2 on, autoseeding

•Type II off

•802.2 SNAP off

IPX Bridging Defaults

•Off

AppleTalk Routing Defaults

•Phase I off

•Phase II on, autoseeding

AppleTalk Bridging Defaults

•Off

DECnet Defaults

•Off

Image 39

Contents MicroRouter 2200R Installation Guide Page Network Installation IntroductionGetting Started Command Line Management Basic Configuration GuideAppendix a Shipping Defaults Systems Appendix E Terms and Conditions Appendix B Connector and Cable Pin OutsIntroduction About the MicroRouter 2200RIntroduction Getting Started MicroRouter 2200R Installation OverviewBasic Configuration Guide Introduction Network InstallationCompatiView Software Installation Command Line PreparationPage Please Read The Manuals Warranty and ServiceGetting Started Few NotesEthernet Connection Requirements Needed For InstallationWhat You Will Need To Get Started Supplied with the MicroRouter 2200RTelco Line Connection Requirements Getting Started 10Base-T Twisted-Pair EthernetInterface RS-232 Interface Placing the Router Network InstallationConnecting Devices to the V.35 Interface Connecting the Router to the EthernetConnecting a Line Device to MicroRouter 2200R Connecting to Twisted-Pair EthernetConnecting Devices to the RS-232C Interface Connecting an Out-of-Band Management ConsolePowering Up the Router Installation and Operation CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementCommand Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide Suggested for IP Ethernet Interface ConfigurationIP Protocol Required for IPIPX Protocol AppleTalk ProtocolDECnet Protocol WAN Interface Configuration Physical Communications SettingsSuggested for DECnet Required for Dial-On-Demand Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Suggested for Dedicated/Leased Line OperationIP Protocol Basic Configuration Guide Suggested for IPX DECnet Protocol Frame Relay Dlci Mappings Frame Relay ConfigurationRequired for IP Unnumbered Interface Required for IP Numbered InterfaceIPX Protocol Smds Configuration Smds Addressing Saving a Configuration File to Flash ROMPage Appendix a Shipping Defaults Default PasswordEthernet Interface WAN Interfaces Pin Outs for V.35 Female Connector DTE Appendix B Connector and Cable Pin OutsAppendix B Connector and Cable Pin Outs Panic Indicators Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bar Other Indicators on All LED BarsAppendix C LED Patterns and Test Switch Settings MicroRouter 2200R Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions