Compatible Systems 2200R manual Appendix B Connector and Cable Pin Outs

Page 42

36	Appendix B - Connector and Cable Pin Outs

Pin Outs for DB-25 Male to DB-25 Female RS-232 Data & Console Cable

The cable supplied with the MicroRouter 2200R is twenty-five conduc- tors, straight through. Connections on both the auxiliary interface and the data interface follow the standard RS-232 pin outs. Note that the data interface may be set for synchronous operation and in this mode the data interface will use the clock lines provided by RS-232.

Image 42

Contents MicroRouter 2200R Installation Guide Page Network Installation IntroductionGetting Started Basic Configuration Guide Command Line ManagementAppendix a Shipping Defaults Appendix B Connector and Cable Pin Outs Systems Appendix E Terms and ConditionsIntroduction About the MicroRouter 2200RIntroduction MicroRouter 2200R Installation Overview Getting StartedCommand Line Preparation Introduction Network InstallationCompatiView Software Installation Basic Configuration GuidePage Few Notes Warranty and ServiceGetting Started Please Read The ManualsSupplied with the MicroRouter 2200R Needed For InstallationWhat You Will Need To Get Started Ethernet Connection RequirementsTelco Line Connection Requirements Getting Started 10Base-T Twisted-Pair EthernetInterface RS-232 Interface Network Installation Placing the RouterConnecting to Twisted-Pair Ethernet Connecting the Router to the EthernetConnecting a Line Device to MicroRouter 2200R Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router Installation and Operation CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Required for IP Ethernet Interface ConfigurationIP Protocol Suggested for IPIPX Protocol AppleTalk ProtocolDECnet Protocol WAN Interface Configuration Physical Communications SettingsSuggested for DECnet Suggested for Dedicated/Leased Line Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Basic Configuration Guide Suggested for IPX DECnet Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Smds Configuration Saving a Configuration File to Flash ROM Smds AddressingPage Appendix a Shipping Defaults Default PasswordEthernet Interface WAN Interfaces Appendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Other Indicators on All LED Bars Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bar Panic IndicatorsMicroRouter 2200R Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions