Compatible Systems manual MicroRouter 2200R Switch Settings

Page 44

38Appendix C - LED Patterns and Test Switch Settings

MicroRouter 2200R Switch Settings

0Normal Operation

1Unused*

2Unused*

3Run Boot ROM Downloader

4Unused*

5Erase Flash ROM (OS and Configuration)

6Erase Flash ROM (Configuration Only)

7Unused*

8Unused*

9Allow letmein password for 5 minutes after powerup

Caution: Settings marked with an asterisk may erase your Flash MROM. Please do not use these settings without first contacting Compatible Systems Technical Support.

Image 44
Contents MicroRouter 2200R Installation Guide Page Getting Started Network InstallationIntroduction Basic Configuration Guide Command Line ManagementAppendix a Shipping Defaults Appendix B Connector and Cable Pin Outs Systems Appendix E Terms and ConditionsIntroduction IntroductionAbout the MicroRouter 2200R MicroRouter 2200R Installation Overview Getting StartedIntroduction Network Installation CompatiView Software InstallationCommand Line Preparation Basic Configuration GuidePage Warranty and Service Getting StartedFew Notes Please Read The ManualsNeeded For Installation What You Will Need To Get StartedSupplied with the MicroRouter 2200R Ethernet Connection RequirementsInterface Telco Line Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet RS-232 Interface Network Installation Placing the RouterConnecting the Router to the Ethernet Connecting a Line Device to MicroRouter 2200RConnecting to Twisted-Pair Ethernet Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Ethernet Interface Configuration IP ProtocolRequired for IP Suggested for IPDECnet Protocol IPX ProtocolAppleTalk Protocol Suggested for DECnet WAN Interface ConfigurationPhysical Communications Settings Link Configuration Required for Dedicated/Leased Line OperationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Basic Configuration Guide Suggested for IPX DECnet Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Smds Configuration Saving a Configuration File to Flash ROM Smds AddressingPage Ethernet Interface Appendix a Shipping DefaultsDefault Password WAN Interfaces Appendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Power On, No Traffic Ethernet Traffic Indicators Ethernet LED BarOther Indicators on All LED Bars Panic IndicatorsMicroRouter 2200R Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions