Rack Mount Installation
The Archive Appliance Express can be rack mounted using a sliding rail kit available from Plasmon. The rack mount kit works in racks with a depth of 22" to 34" (56 to 142 cm) from front to back rails.
Short L Brackets | Long L Brackets |
Sliding Rail | Fixed Rail |
Figure 5. Rack Mounting Kit for AAE
To install the rack mounting rails, perform the following steps:
1.Separate the sliding rail from the fixed rail by fully extending the sliding rail and releasing the stop latch shown below. Repeat for the other rail.
Push up to release
sliding rail.
2.Attach the sliding rails to the sides of the AAE by inserting the notched ends of the sliding rails into the raised tabs toward the front on each side of the AAE, and attaching the rails with two M4, 12mm x 20 screws on each as shown below.
Notched End | Mounting Screws |
Plasmon AA Express User Manual | Hardware Installation |
Document Revision B | Page 15 |