55555 | 5 |
2.Slide the hard disk drive towards the front to disconnect it from the I/O board.
Fig. 4 Removing the hard disk drive.
3. Lift the hard disk drive out of the device (see Fig. 4).
I/O Board
To remove the I/O board, first remove the front cover (see Front Cover on page 3), remove the top cover (see Top Cover on page 3), remove the hard disk drive (see Hard Disk Drive on page 4), and then perform the following steps:
1. Remove the 2 screws securing the I/O board.
Fig. 5 Removing the I/O board.
2.Disconnect the LED cable from the header on the I/O board (see Fig. 5).
3.Carefully take out the I/O board from the device.
Packard Bell Grafite & Carbon Disassembly Manual