Installation and Connection | DRS5116 |
|
|
(1)After a sensor is connected, it can be activated through the OSD Configuration menu.
(2)Select the sensor number (S1, S2, etc.) and press the [Enter] button to configure. Use the [◄◄/►►] buttons to select “On” or “Off.” Press the [EXIT] button when finished.
(3)When activated, the “Pre/Post Alarm” function will cause the
<Note>
1.This menu is used to set sensor using and sensor type. However, recording by sensor input and relay output should be set in another menu.
2.For recording setting by sensor input, refer to the “Alarm Rec.” part of the “ DRS Programming Guide”.
3.For relay output, refer to the “Alarm Act.” part of the “DRS Programming Guide”.
Wren | 2003. 09. 06 (v 1.0) | 37 |
