1616161616 | 16 |
5. Remove the 8 screws securing the LCD and lift out the LCD panel.
Fig. 28 Location of screws securing LCD module.
6.Remove the 4 screws on each side of the bracket.
7.Remove the top support bracket (usually held in place by the left and the right brackets).
8.Disconnect the LCD cable from the back of the panel.
Inverter Board
To remove the inverter board, first remove battery (see Battery), the HDD (see Hard Disk Drive), the CD- ROM or DVD drive (see Optical Disk Drive), the wireless network card (see WLAN Card), the installed memory (see Memory), the CPU (see Processor), the keyboard (see Keyboard), remove the LCD screen (see LCD Screen Assembly), disassemble the LCD panel up to step 3 (see LCD Panel), and then do the following:
1.Disconnect all cables from the inverter board (see Fig. 27).
2.Remove the screw securing the inverter board (see Fig. 27) and extract the board.
Note: The protective Mylar around the inverter board is a separate service part.
Webcam
To remove the webcam, first remove battery (see Battery), the HDD (see Hard Disk Drive), the
1. Disconnect the cable from the webcam.
Fig. 29 Location of webcam connector.
2. Lift out the webcam.
Packard Bell EasyNote MX Disassembly Manual