Load Default Settings
When you press <Enter> on this item, you will get a confirmation dialog box with a message similar to:
Load Default Settings (Y/N) ? N
Pressing 'Y' loads the default values that are
Set Supervisor/User Password
Steps to set supervisor/user password are described as follows:
New Password Setting:
1.While pressing <Enter> to set a password, a dialog box appears to ask you enter a password.
2.Key in a new password. The password can not exceed eight characters.
3.System will request you to confirm the new password again.
4.When completed, new code takes effect.
No Password Setting:
5.If you want to delete the password, just press the <Enter> key instead of typinga new password. Follow the procedure as ablve.
If You Forget Password:
6.If you forget your password, you must turn off the system and clear
CMOS. Please refer to the tech notes at the end of section two for more information.
English
21