Safety Status: SELV
No voltages within this equipment exceed SELV voltages. All interconnection points and ports are SELV.
User/Installer Instructions for the United Kingdom
Important Safety Considerations When Installing Into A Host Computer System
The Eiconcard C2x is a single PCI card.
Installation Within A Spare Slot Position
Warning: It is essential that, when other option cards are introduced which use or generate a hazardous voltage, the minimum creepages and clearances specified in the table below are maintained. Suitable user protection to ensure compliance with EN60950/A4 should be present on the card. A hazardous voltage is one which exceeds 42.4V peak a.c or 60V d.c. If you have any doubt, seek advice from a competent engineer before installing other adapters into the host equipment.
The equipment must be installed such that with the exception of the connections to the host, clearance and creepage distances shown in the table below are maintained between the card and any other assemblies which use or generate a voltage shown in the table below.
Clearance | Creepage | Voltage used or generated by other | ||
parts of the host or expansion card | ||||
X mm | Y mm | |||
Vrms or Vdc | ||||
|
|
| ||
2.0 | 2.4 | (3.8) | up to 50 | |
2.6 | 3.0 | (4.8) | up to 125 | |
4.0 | 5.0 | (8.0) | up to 250 | |
4.0 | 6.4 | (10.0) | up to 300 | |
|
|
|
| |
Table 4. Creepage Distances
The larger distance shown in brackets applies where the local environment within the host is subject to conductive pollution or dry
The clearance distance X is the shortest distance in air between two points. The creepage path Y (along surfaces) is the shortest distance between the same two points.
Regulatory Information for Europe | 21 |