A.Identify if M/B is AT or ATX.
B.Remove M/B mounting plate by pulling Latch towards back of chassis and swinging out the plate (Fig. 8).
C.Make sure punch out holes for I/O ports on
the I/O plate are punched out matching
Fig:8
ports on the M/B.
D.Install at an angle, first by lining up the I/O ports on the M/B with I/O plate (Fig. 9).
E.Once holes are lined up, set M/B on standoffs and stakes, make sure the M/B is seated properly and fasten M/B using hex head screws.
screw holes will vary with manufacturer.
Fig:9
Please refer to M/B user manual for more details.) Connect wires as directed in M/B user manual.
G.Reinstall M/B mounting plate and swing into Place.
Slide in to P/S area and fasten with hex head screws (Fig. 10).
Fig:10