Abit IS7-M, IS7-G, IS7-E2V, IS7-E2G, IS7-V2 user manual

Page 49

BIOS Setup

3-9

 

 

Report No FDD For OS:

When set to [Yes], this item allows you to run some older operating system without floppy disk drive. Leave this item to its default setting.

Delay IDE Initial (Secs):

This item allows the BIOS to support some old or special IDE devices by prolonging this delay time. A larger value will give more delay time to the device for which to initialize and to prepare for activation.

Intel OnScreen Branding:

This item determines whether to display the “Intel Inside” logo or not at system boots up.

Disable Unused PCI Clock:

This option disables the clock of PCI slot that is not in use.

[Yes]: The system automatically detect the unused DIMM and PCI slots, and stop sending clock signal to these unused PCI slots.

[No]: The system always send clock signal to all PCI slots.

NOTE: Set this option to [No] setting if there are adapters that cannot be automatically detected by the system and will cause malfunction.

User’s Manual

Image 49
Contents IS7 Series Copyright and Warranty Notice Table Of Contents Appendix a Introduction Features & SpecificationsAudio Order Information Layout Diagram IS7-G/IS7/IS7-E Layout Diagram IS7-E2/IS7-E2G/IS7-E2V Layout Diagram IS7-M Layout Diagram IS7-V2 IS7 Series Install The Motherboard Hardware SetupInstall Pentium 4 CPU and Heatsink Supporting-Base IS7-G/IS7/IS7-E/IS7-M Install System MemoryIS7-E2/IS7-E2G/IS7-E2V/IS7-V2 Page Connectors, Headers and Switches Page IS7-V2 USB-PWR1 VCC VCC Chapter Page Page GND IS7-G/IS7/IS7-E/IS7-M Hardware Setup System Management Bus Headers Chapter Hardware Setup IS7-E2/IS7-E2G/IS7-E2V IS7-V2 User’s Manual Page Page Chapter Page IDE1 IDE2 SATA1 SATA2 Page IS7-E2/IS7-E2G/IS7-E2V IS7-V2 IS7 Series Page Chapter Press DEL to Enter Setup Bios SetupUser Define SoftMenu SetupPage Standard Cmos Features Back to Standard Cmos Features Setup Menu Chapter Advanced Bios Features Chapter Page Dram Timing Selectable Advanced Chipset FeaturesPage OnChip IDE Device Integrated PeripheralsSata RAID ROM SATA1 SATA2 OnChip PCI Device SuperIO Device Bios Setup UR2 Duplex Mode Onboard PCI Device Power Management Setup WakeUp by Alarm Page PnP/PCI Configurations AGP LAN PC Health Status Load Optimized Defaults Load Fail-Safe DefaultsSet Password Save & Exit SetupIS7 Series Appendix A. Install Intel Chipset Software Utility Appendix a Install Intel Application Accelerator RAID IS7-G, IS7 Click Next Click Finish to complete setup IS7 Series Intel Serial ATA RAID Configuration Utility IS7-G Appendix B Appendix C. Install Audio Driver Appendix C Appendix D. Install LAN Driver Appendix D Appendix E. Install Silicon Serial ATA RAID Driver IS7-G Click Finish RAID Configuration Utility Menu Bios Setup for Serial ATA RAID IS7-GOption Delete RAID set Appendix F. Install VGA Driver IS7-M Appendix F Appendix G. Install USB 2.0 Driver Appendix G Appendix H. Abit EQ The Hardware Doctor Utility Appendix H Appendix I. FlashMenu Bios Update Utility Appendix Appendix J. Troubleshooting Need Assistance? Appendix J User’s Manual Technical Support Form Appendix K. How to Get Technical Support Appendix K 4QX, UK Thank You Abit Computer Corporation