Infrasonic BLOW5D user manual Connection, Powering UP, Analog Audio Input

4.CONNECTION

4.1.POWERING UP

IMPORTANT NOTE

ƒAll connections should be made, And faders, volumes, sensitivity and other controls are at minimum levels.

ƒBefore powering up the BLOW5 speakers, all other equipment should be turned on first.

ƒPlease make sure that the unit is plugged into the correct voltage.

ƒThe power switch is located on the rear panel.

ƒTurn on the power to the BLOW5.

ƒThe unit is equipped with a protection circuit, an interval of a few seconds is required before the unit will operate normally.

4.2.ANALOG AUDIO INPUT

ƒConnect the male side of an XLR balanced cable to the XLR input or TRS balanced (or unbalanced) cable to the TRS input of the rear panel.

ƒInput Select Switch should be set to analog input.

ƒRefer to the following diagram.

XLR balanced cable

< Connecting of Analog XLR balanced cable >

TRS balanced cable

TRS unbalanced cable

< Connecting of TRS Analog balanced/unbalanced cable >

BLOW5/BLOW5D User’s Manual 11