Ingersoll-Rand 7978-() manual NON-EU Models

Page 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.

WARNING

Wear eye protection when operating or performing maintenance on this tool.

WARNING

Turn off air supply and disconnect air supply hose before installing, removing or adjusting any accessory on this tool, or before performing any maintenance on this tool.

WARNING

Do not carry the tool by the hose.

WARNING

Do not overreach when operating this tool. Keep body stance balanced and firm.

NOTICE

WARNING

Read the manual before operating this tool.

Operate at 90 psig/6.2 bar max.

WARNING

Wear hearing protection when operating this tool.

WARNING

Air powered tools can vibrate in use. Vibration, repetitive motions or uncomfortable positions may be harmful to your hands and arms. Stop using any tool if discomfort, tingling feeling or pain occurs. Seek medical advice before resuming use.

WARNING

Do not use damaged, frayed or deteriorated air hoses and fittings.

WARNING

Operate at 90 p.s.i.g. (6.2 bar/620 kPa) maximum air pressure.

PN 48176–1 LABEL

PN 49883 LABEL

(NON–EU MODELS)

(–EU MODELS)

This label must appear on the tool at all times. If it is lost or damaged, a replacement label is available at no cost.

WARNING = Hazards or unsafe practices which could result in severe personal injury, death or substantial property damage.

CAUTION = Hazards or unsafe practices which could result in minor personal injury or product or property damage.

NOTICE = Important installation, operation or maintenance information.

2

Image 2
Contents OPERATOR’S Manual 60,000 R.P.M. Pencil GrinderNON-EU Models Recommended Lubricants Routine Lubrication RequirementsAIR Supply Requirements Mounting InstructionsThrottle Section DISASSEMBLY/ASSEMBLY InstructionsModel Identification Motor SectionSemble blades to rotor Blades from rotor Ly with punch as for motor disassemblyTo housing using thread adhesive on threads and tighten se Rotor Race of bearing 46110 to remove axial playDimensional Data Typical Cross Section of ToolM10 PN 49999-247