MOTOR SECTION | M10 | |
DISASSEMBLY |
| 15 |
_ Assemble end plate (46108), with spacer (46103), to rotor. Us- | ||
| ing brass blocks in a vise, as for disassembly, clamp on rotor | |
_ Remove motor assembly as outlined on page 4. | and assemble collet body to rotor (apply thread adhesive to | |
_ Grasp cylinder in one hand and, with the same hand, hold a | threads) and tighten to 20 – 25 in. lbs torque. |
|
punch against the rear of the rotor. Tap punch to remove bear- | _ Coat i.d. of cylinder with spindle oil and assemble to rotor. As- | |
ing (46110) and end plate (46107) from rotor. Remove cylinder | semble blades to rotor. |
|
and blades from rotor. | _ Pack bearing (46110) with ARO 33153 grease and assemble | |
_ Using brass blocks (1/4” diameter) in a vise; clamp on rotor | to end plate (46107). |
|
and remove collet body, bearing, end plate and spacer from | _ Assemble end plate to rotor. Push rotor to rear and press inner | |
rotor. | race of bearing (46110) to remove axial play. |
|
ASSEMBLY | _ Be sure rotor does not bind. If rotor binds, tap rear of rotor light- | |
ly with punch as for motor disassembly. |
| |
| _ Assemble motor assembly to housing and assemble throttle | |
_ Pack bearing (46109) with ARO 33153 grease and assemble | to housing using thread adhesive on threads and tighten se- | |
to end plate (46108), with shielded side out. | curely. |
|
MOTOR ASSEMBLY 46112–( )
37738 WRENCH (FURNISHED WITH TOOL) | OPTIONAL FILTER ASSEMBLY (1/4”) |
5