Iiyama MA203DT D user manual Connecting Your Monitor

Page 10

ENGLISH

CONNECTING YOUR MONITOR

AEnsure that both the computer and the monitor are switched off.

BConnect the computer to the monitor with the signal cable. (See page 17 for CONNECTOR PINASSIGNMENT.)

CConnect the Power Cable to the monitor first and then to the power supply.

NOTE ￿ The signal cables used for the connection vary by the type of computers you use. An incorrect connection may cause serious damage to both the monitor and the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector. If a special cable is required please contact your local iiyama dealer or regional iiyama office.

￿For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama office for a suitable adaptor.

￿Make sure you tighten the finger screws at each end of the signal cable.

7 BEFORE YOU OPERATE THE MONITOR

Page 9 Page 11
Image 10
Page 9 Page 11
Contents MA203DT D Congratulations FCC Declaration of Conformity For Your Safety Safety PrecautionsDo not Touch the Plug with WET Hands Customer Service CleaningAccessories FeaturesBefore YOU Operate the Monitor For Windows 95/98/2000/ME/XP Users Location of Controls OPQ OFFConnecting Your Monitor Menu Screen Control Operating the MonitorAdjustment Menu Contents Size Too small Convergence To correct misconvergence For horizontal lines Function Power Management Feature Trouble Shooting Normal phenomenon on ‘Diamondtron NF-CRT’ monitors Specifications AppendixPreset Modes Connector PIN AssignmentIiyama Corporation
Top Page Image Contents