The installation program will let you specify whether it should search for a driver or display a list of drivers. Controls for specifying a search location will also appear.
Step 2. Click Search for the best driver for your device (Recommended), put a check mark on Specify a location, type a:\ into the location box, and then click Next.
You may be instructed again to insert the disk and specify the driver’s location. If this happens, click OK, type a:\ under Copy files from, and click OK again.
The installation program will indicate that it found the driver.
Step 3. Click Next.
After completing the above steps, confirm all subsequent messages (that is, click Next, Finish, OK, or Yes), remove the driver disk, and allow the system to restart.
Windows 2000
In Microsoft® Windows 2000, the window that appears when you first connect the adapter is titled Found New Hardware Wizard. Install the driver as follows:
Step 1. Make sure the driver disk is in drive A, and then click Next.
The installation program will let you specify whether it should search for a driver or display a list of drivers.
Step 2. Click Search for a suitable driver for my device (recommended), and then click Next.
The installation program will display several “optional search locations.”
Step 3. Put a check mark on Specify a Location, remove any other check marks, and then click Next.
Controls for specifying a location will appear. Step 4. Type a:\ into the location box, and then click Next.
The installation program will find the driver and display information about it.
Step 5. Click Next.
A message about a “digital driver signature” not being found may appear. Click Yes to continue with installation.
InstantWave | 7 |