∙If desired, connect a PC (server) to the DMZ port. To use multiple servers, use a standard LAN cable to con- nect the DMZ port to a normal port on another hub, and connect your servers to the hub. PCs connected to the DMZ port are isolated from your LAN.
3.Connect your DSL/Cable Modem to the WAN port. Use the cable supplied with your DSL/Cable modem, or a standard network cable.
4.Connect the supplied Power Adapter and power on.
5.Check the LEDs
∙The Status LED should flash, then turn Off. If it stays on, there is a hardware error.
∙The WAN LED should be ON.
∙For each active LAN (PC) connection, the LAN Link/Act LED should be ON.
•Configuration
1.Start your PC. If it is already started, restart it.
It will then obtain an IP Address from the Soho 401 VPN 's DHCP Server.
2.Start your WEB browser. In the Address box, enter the following:
HTTP://192.168.0.1
3.The Setup Wizard will run automatically.
4.Step through the Wizard until finished. Refer to the data from your ISP, and the table below, as necessary.
Connection Type | Data required. |
|
|
Dynamic IP Address | Usually, none. |
| But some ISPs may require a |
| Hostname, Domain Name, or |
| MAC (physical) address. |
|
|
Page 2