HotBrick LB-2 manual Settings LAN & Dhcp, IP Address, Subnet Mask, Dhcp Server, Configuration

HotBrick Network Solutions

9. Select LAN & DHCP from the menu. You will see a screen like the example below.

Figure 6: LAN & DHCP

10.Ensure these settings are suitable for your LAN:

•The default settings are suitable for many situations.

•See the following table for details of each setting.

11.Save your data, then go to Step 2, Installing the Load Balancer LB-2 in your LAN.

Settings – LAN & DHCP

IP Address	IP address for the Load Balancer LB-2, as seen from the local LAN. Use the
	default value unless the address is already in use or your LAN is using a
	different IP address range. In the latter case, enter an unused IP Address
	from within the range used by your LAN.
Subnet Mask	The default value 255.255.255.0 is standard for small (class "C") networks.
	For other networks, use the Subnet Mask for the LAN segment to which the
	Load Balancer LB-2 is attached (the same value as the PCs on that LAN
	segment).
DHCP Server	• DHCP Server Setup - If Enabled, the Load Balancer LB-2 will allocate IP
Configuration	Addresses to PCs (DHCP clients) on your LAN when they start up. The
	default and recommended value is "Enable". (Windows systems, by

10