Hand Held Products 4200 quick start Connecting the Imager for USB, USB Interface Selection

Page 7

Connecting the Imager for USB

A imager can be connected to the USB port of a computer.

1.Connect the appropriate interface cable to the imager.

2.Connect the other end of the cable to the computer.

Note: The cable must be connected at the imager end (1) before the PC (2) end is connected.

1

2

3.The imager beeps.

4.Scan the appropriate bar code below for the desired USB configuration.

USB Interface Selection

Note: USB Keyboard and USB HID drivers are included with Microsoft® Windows® 98 SE or later. The USB COM Port Emulation driver can be downloaded from the Hand Held Products website (www.handheld.com).

USB Keyboard (PC)

(Default)

USB Japanese Keyboard (PC)

USB HID Bar Code Imager

USB COM Port Emulation

IMAGETEAM™ 4200 Quick Start Guide

3

Image 7

Contents Quick Start Guide Disclaimer Table of Contents Page IT4200 with Green LED Aimer Imager Identification Getting StartedReading Techniques USB Interface Selection Connecting the Imager for USBKeyboard Wedge Connecting Imager for Keyboard Wedge Powered by HostRS-232 Serial Port Connecting the Imager for RS-232 Serial Port External PowerSuffix Selections Useful Menu Bar Codes Manual/Serial Trigger ModePresentation Mode Resetting the Standard Product DefaultsBeeper and LED Sequences and Meaning To Add a Test Code I.D. Prefix to All SymbologiesMaintenance Cleaning the Imager’s WindowReplacing the Interface Cable Inspecting Cords and ConnectorsTo Replace the IT4200 Interface Cable TroubleshootingImager won’t read your bar code at all Obtaining Factory ServiceTechnical Support Regulatory and Safety ApprovalsStatement of Agency Compliance Patents Limited WarrantySolids and Water Protection Imageteam 4200 Quick Start Guide Imageteam 4200 Quick Start Guide Page Hand Held Products, Inc