Hand Held Products 4200 quick start Connecting the Imager for RS-232 Serial Port External Power

Page 9

Connecting the Imager for RS-232 Serial Port (External Power)

1.Turn off power to the terminal/computer.

2.Connect the appropriate interface cable to the imager.

2 3

4

3.Plug the serial connector into the serial port on your computer.

4.Connect the external power supply to the cable.

5.Power up the computer and imager.

RS-232 Serial Port

Scanning the RS-232 interface bar code, programs the imager for an RS-232 interface at 38,400 baud, parity–none, 8 data bits, 1 stop bit, and adds a suffix of a CR LF.

RS-232 Interface

IMAGETEAM™ 4200 Quick Start Guide

5

Image 9

Contents Quick Start Guide Disclaimer Table of Contents Page IT4200 with Green LED Aimer Imager Identification Getting StartedReading Techniques USB Interface Selection Connecting the Imager for USBKeyboard Wedge Connecting Imager for Keyboard Wedge Powered by HostRS-232 Serial Port Connecting the Imager for RS-232 Serial Port External PowerPresentation Mode Useful Menu Bar Codes Manual/Serial Trigger ModeResetting the Standard Product Defaults Suffix SelectionsMaintenance To Add a Test Code I.D. Prefix to All SymbologiesCleaning the Imager’s Window Beeper and LED Sequences and MeaningReplacing the Interface Cable Inspecting Cords and ConnectorsTo Replace the IT4200 Interface Cable TroubleshootingImager won’t read your bar code at all Obtaining Factory ServiceRegulatory and Safety Approvals Technical SupportStatement of Agency Compliance Limited Warranty PatentsSolids and Water Protection Imageteam 4200 Quick Start Guide Imageteam 4200 Quick Start Guide Page Hand Held Products, Inc