Pre-Installation Recommendations

During Installation

•DO NOT connect this docking station to the vehicle battery until:

1.ALL other electrical connections are made

2.Mounting of ALL components are complete

3.VERIFICATION that no shorts exist in the entire system

•DO NOT install equipment or route wiring or cords in the deployment path of any air bag.

•When drilling into the vehicle, DO make sure that both sides of the surface are clear of anything that could be damaged.

CAUTION: If wiring is shorted to the frame, high current conductors can cause hazardous sparks resulting in electrical fires or flying molten metal.

After Installation

•Test the docking station to ensure that it is working properly.

File these instructions in a safe place and refer to them when performing maintenance or re-installing.

WARNING: Failure to follow all safety precautions and instructions may result in property damage, serious injury or death.

Conduct a "Bench Test"

Gamber-Johnson strongly advises a "bench test" be conducted to verify that all electronic and software issues are resolved prior to installation:

1.Make sure computer is operational by itself.

2.Insert computer into docking station and verify that the computer is operating in the dock.

3.Interconnect entire assembly and verify start-up of all components, including other equipment (printers, modems, scanners, etc.).

*Gamber-Johnson also recommends positioning of all mounts and equipment in the vehicle prior to the actual install to verify that mounting locations are safe and practical.

Page 3 of 8