Power Switch

This docking station has a power switch with an LED light (see Figure 1):

•"INPUT POWER" - The green LED light, built into the power switch, indicates that there is power to the unit.

•Standard Installation - In this set-up, the power switch can be turned on and off to regulate power through the unit.

•By-Pass Installation - In this set-up, the unit is continuously powered (bypassing the power switch) and the green LED light is lit regardless of switch position.

*Refer to the Power Supply and Wiring Instructions sections of this manual for further information regarding these features.

Red, Black &

Blue Wires w/

Disconnect

Figure 1

Power Switch w/

Green "POWER" LED

POWER SUPPLY INFORMATION

This docking station has a built-in power supply and is designed to be used with an 11 - 28 volt DC system. The voltage output is factory set at 19 volts.

Power is provided using the wires located on the underside of the docking station:

•Standard Installation - Use the RED and BLACK wires to utilize the power switch on the docking station, regulating power through the unit.

•By-Pass Installation - Use the BLUE and BLACK wires to continuously power the docking station and bypass the power switch.

Page 4 of 8