2.Flash Tool will ask you to hold down the power button on your EVBot for 7 seconds to enter Flash Mode, then click OK to start Flashing.
3.Flash process will take several minutes, please be patient and do not turn off the PC or reset during this period!
4.EVbot Screen will be flashing it’s blue light on and off during the flash process.
5. When Flash is done, Flash Tool will prompt you to unplug and replug EVBot and it is ready for use.
If some problem causes you to stop the flashing of firmware intermittently, unplug the EVBot connection, Hold down on Power button and don’t let go and replug cable into EVBot, holding down on Power button at least 7 seconds till you see this:
EVBot is in Flash Mode again and you can reflash it by repeating the same method. As long as the Flash Tools can detect EVBot, then it can be reflashed again.